| Part name: | build or rebuild your long block type 4 from the main bearings out |
| Part number: | ylb4 |
| Your cost: | $700.00 |
| Description: | To have your VW type 4 long block rebuilt from the main bearings out by us, you must supply the following:
If the rods need rebuilt, they'll get sent out for: rebushing, end to end balancing & mate balancing & new nuts. If the crank needs work of any kind, it will get sent out for that. The crank gear 'set' will be reused unless damaged from a 'blow up'. The block will be cleaned in our solvent tank, rinsed with Super Clean & water then blown dry with compressed air, then inspected. If the block needs align boring it'll get sent out for that & new main bearings with the rear main cut to fit. The flywheel will be cleaned in our solvent tank. All new bearings go inside for the rods & cam as well. The cam will be inspected for pits or other wear as well as the lifters. If ANY pitting or wear is present, you will get a new cam & lifters. If you have a rivet on gear, you'll get a bolt on gear for this build. The end play will be set using new shims if necessary. The oil pump will get inspected for pitting or wear. If any is found you'll get a new oil pump. The pressure relief spring & plunger kit will be replaced with new. I'll install a new piston & cylinder kit with Total Seal Gapless 2nd rings. I'll inspect & possibly reuse your heads (they will NOT be cleaned other than a rinse in the solvent tank). If they leak or are cracked they'll be sent out for repair. I'll install new pushrod tube seals. I'll clean & blow out the pushrods. I'll inspect & reinstall your valve train at the correct lash & install the valve covers. A new engine gasket kit will be used & you'll get the left over gaskets & seals. |