Doghouse Engines - build or rebuild your long block type 4 from the rod bearings out

Part name:	build or rebuild your long block type 4 from the rod bearings out
Part number:	rod bearings out
Your cost:	$500.00
Description:	To have your VW type 4 long block rebuilt from the rod bearings out by us, you must supply the following: A clean long block. Pressure wash at a car wash or steam clean the engine before bringing it to be rebuilt Bring the long block, which consists of: The drain plate on the bottom The flywheel (the clutch & p-plate can be there too) on the back Nothing on the front of the crank - the shroud & fan etc must be off No shrouding or tin or exhaust components Nothing on top Drain the oil. Bring with no oil in it $500 for labor only, with parts, machine work, and any related shipping being extra. I will tear it down to the rod bearings, replace the rod bearings, inspect & possibly reuse the rods. If the rods need rebuilt, they'll get sent out for: rebushing, end to end balancing & mate balancing & new nuts. I'll install a new piston & cylinder kit with Total Seal Gapless 2nd rings. I'll inspect & possibly reuse your heads (they will NOT be cleaned other than a rinse in the solvent tank). If they leak or are cracked they'll be sent out for repair. I'll install new pushrod tube seals. I'll clean & blow out the pushrods. I'll inspect & reinstall your valve train at the correct lash & install the valve covers. Of course any gaskets encountered in the process will be replaced with new.